Large DuraHand Non-Sterile Surgical Hand Immobilizer

Always Sterilize DuraHand prior to use. If the DuraHand coating is cracked, discard the device immediately and do not use.

Sterilization Instructions: Device must be cleaned prior to sterilization. The preferred cleaning solution is ISI's Hemaway Tri-Max, but if unavailable, any non-acidic, general purpose cleaner suited for standard surgical instruments is acceptable. The DuraHand should then be autoclaved.

Cycle Type: Pre-Vac Steam Sterilization Full Cycle Instructions

• Double wrapped in standard central supply wrap
• Sterilization Temperature: 132°C
• Sterilization Exposure Time: 4.0 Minutes

Cycle Type: Gravity Steam Sterilization Full Cycle Instructions

• Double wrapped in standard central supply wrap
• Sterilization Temperature: 121°C

DuraHand Instructions for Use:

• Place patient's hand on top the surgical DuraHand
• Bend wrist tabs over patient's wrist and finger tips over patient's fingers as needed. The patient's hand should then be flat and immobilized. The tab opposite of the thumb can be used as a "kickstand" to prevent the wrist from rolling.
• After procedure, straighten DuraHand fingers and wrist tabs.
• DuraHand must be cleaned in accordance with standard institutional protocol prior to sterilization.
• Sterilize according to "Sterilization Instructions" provided.
• Handle and dispose of in accordance with accepted medical practice and applicable laws and regulations.

The reusable DuraHand Immobilizer can be used on an average of 30 times contingent upon handling of the product. If there are any signs of cracking or breakdown of the coating, the DH will need to be replaced.